Dust Collector Pulse Jet Type
INTRODUCTION
This type of bag filters are operating with a principle known as pulse cycle by which the time interval between pulsing a row of bag to clean them and that row being pulsed again and again.
It is done by a method by which the compressed air is allowed through a tube. A nozzle or a venturi is place at the top portion of the bag.
CONSTRUCTION
In Dust Collector Pulse Jet Type , the bags are supported by the individual metallic cages. These cages are made up of steel and having the strength in it. These cages are fastened with the help of cell plates at the top of the body. In this type of dust collectors the dirty gases enters at the bottom of the bag filter and leaves from the top of the bag without any dirt content. The compressor is used to allow or inject the air into the nozzle or venturi.
WORKING PROCESS
The pressurized air injected through the nozzle of the filter bags. This air is then accelerated with the help of the venturies which is mounted on the top of the bag .Although the dirty gases enters at the bottom of the bag filter and leaves from the top of the bag without any dirt content. The compressor is used to allow or inject the air into the nozzle or venturi. This air is then travel in the entire section of the filter bag. The continuous moving of the air provides the much air to cloth ratio that is 6 to 10 feet/min. In this way Pulse jet type dust collector works.
COMPONENT USED
The following components which are used as follows
Solenoid Valve
Tube Sheets
Compressed air manifold
Venturi
Metallic Cages
Bag supported Cage.
TECHNICAL ASPECTS
It uses the low pressure of blower to enter the air in to the bag
If these are used in the some small works then we get the portable size
In the case of using in the industrial purposes these may be 2-5 m^3
The velocity of the air inlet may got by the formula
Q=V*A
Q=Discharge/Volume of air
A = Tube internal cross-section area (in square feet)
V= Velocity of air in feet/min.
It have the pressure of 10-15 psi.
It uses the positive displacement blower.
GENERAL MANUFACTURER
P-square Technologies
Yansons Engineering Pvt. ltd
R.k Engineering
Real Boilers
Sangola Power & Enviro ltd.
Sigma technologies
« Coolant or cutting oil filter belts rolls Fabric : The Textile Material »
Tell us Your Queries, Suggestions and Feedback